INSTALLATION INSTRUCTIONS
9002-2750v1.doc instructions V1 7-12-16
Page 4 of 5
JM
Important Notes:
•
Camera must be connected to RCA
connection and power before
testing. If camera is not properly
connected before vehicle is put into
reverse, a Camera not available
message will display and the
camera will not function until the
vehicle power is turn off and back
on.
•
This interface can only be used on
one vehicle. After initial
programming this kit will be locked
to the VIN of the vehicle. There is
no reset or un-programming
procedure for this interface. If
vehicle modules are replaced or
reprogrammed to factor
specifications at the dealer, this kit
can be used to reprogram the same
vehicle to re-enable rear camera.
•
Depending on vehicle configuration,
display may stay in reverse camera
mode until vehicle is driven to pre-
determined speed. This is a factory
function.
Find the part number on the back
of the display and verify
compatibility.
