Brahler DIGIMIC, Руководство по эксплуатации

Страница: 18 / 46

Autonomous mode
18
DIGI MIC®
wireless
In autonomous mode, there is only one VOX mode, which corresponds to VAU mode - see also manual
DIGIMIC wired. A limitation of the active microphones is not necessary, since only 4 microphones can be
activated simultaneously in the wireless system, e.g.
- 4 delegates
- 1 chair 3 delegates
- 2 chairp 2 delegates
The VOX mode is enabled at the DSpark as described below.
VOX mode
ON/OFF
Volume down
continuously
Volume up
continuously
Press and
hold
VOX Vol Down Vol Up Mode
Figure 9
The operator presses and holds the button "LS INTERN". After two seconds the DSpark is in a submode for
configure. The LED “LS INTERNAL” flashes:
Important: The button must be pushed keeping on.
VOX mode ON / ONN:
The operator presses also the button "REGISTER" to switch VOX mode on or off.
When VOX mode is activated the LED "REGISTER" is flashing (only during pressing the button "LS
INTERN").
VOX activation or deactivation is effective immediately.
Volume control
As long as the button INTERN LS is pressed and held you may adjust the volume of the microphones
loudspeakers using the buttons "HIGH POWER" and "PRIO".
- "HIGH POWER" = volume down
- "PRIO" = volume up
Pressing one of these buttons the volume level is changed successive.
All changes are effective immediately. After releasing the button "LS INTERN" the changes are automatically
saved as a new default value. After restarting the DSpark the new values are available.
Releasing the key "LS INTERN" the DSpark operates in standard mode.