Brady Bradyprinter 300 MVPplus, Краткое руководство пользователя, Страница: 10 / 20

EN-8 13293LB-12 Rev. 2 16Nov2004 English
Bradyprinter THT MVPplus Quick Reference Guide
Position the Reflective Sensor
Position the Reflective Sensor
Refer to Figure 6 .
1.
Open the printhead assembly and turn on the AC power.
2.
Locate the reflective sensor positioning lever.
3. For non-continuous media: Move the lever across the width of the media to align the
reflective sensor with the start-of-label indicator (notch, hole, black mark, or gap). The
glow of the red LED through the media helps to position the sensor.
4.
For continuous media: Position the reflective sensor anywhere under the media so that a
“MEDIA OUT” condition can be sensed.
5. Ensure that the media and ribbon are properly positioned.
6.
Close the printhead assembly.
Figure 6 • Position the Reflective Sensor
Note • This sensor is typically covered by a factory-installed plate. If you need to enable this
sensor, you must remove the plate.
Printhead
Transmissive
Sensor
Reflective
Sensor
Reflective Sensor
Positioning Lever