Brady BradyJet J5000, Руководство оператора

Страница: 16 / 36

J5000 Operator’s Guide, Rev. 1.53
8
enough into the throat of the printer (about 3in or 75mm) to correctly position the
Movable Throat Guide but not yet into the printer itself.
8.
Slide the Movable Throat Guide inward until it
almost
touches the label stock.
Important Note:
The label stock should be close enough to the Fixed and Movable
Throat Guides to provide proper guidance but not close enough to pinch the label
stock. If the label stock is pinched by the guides, poor print quality or feeding
problems could result.
9.
Feed the label stock further into the printer until it senses the label and
automatically feeds it through the printer. If the printer fails to feed the label stock,
press the Load/Feed button on the front panel while continuing to guide the label
stock into the printer. If the printer does not automatically grab and feed the stock
or continues to feed the stock without stopping check the Stock Sensor position or
mode.
C: Set the Output/Cut Mode
Use the Output/Cut Mode to adjust how the printer presents labels after they are
printed or if/when they are cut after printing. To adjust the Output/Cut Mode, open
the Brady Status J5000 program. The Brady Status J5000 automatically installs with
your printer driver and can be accessed through the printer driver or as a program that
is accessible in the same manner as all other programs.
1.
Connect the printer via USB and turn on the power. The Output/Cut Mode Setting
is stored on the printer main board so you will not be able to access it unless the
printer is turned on and properly communicating with the computer.
2. Go to Start - Programs – Brady Corp – Brady Status J5000 .
3. Click on the Alignment Tab (3rd tab from top).
Movable Throat Guide Fixed Throat Guide