WC7180
Installation
4
7/15/09
Bradley Corporation • 215-326 Rev. G; EN 08-705
Installation
NOTE: Back supply is shown, top supply is similar.
Insert six 1/2"-13 threaded
studs (provided by the
installer) into the back of
the unit and screw in
approximately 1/2".
A
BACK SUPPLY: Connect the
flush valve supply pipe to the
1-1/2" NPT inlet half coupling
on the back of the unit.
TOP SUPPLY: Connect the
flush valve supply pipe to the
1-1/2" NPT inlet half coupling
on the top of the unit.
B
Slide the studs and pipe through the wall
openings and position the unit into place.
Secure the unit to the wall using the nuts
(110-119), washers (142-002AM) and
brackets (140-277) provided. Fasteners
must be securely tightened to 60 ft. lbs.
C
Connect the drain
pipe to the waste
fitting on the back
of the unit.
D
