4
Bradley TouchTime
®
Individual Built-In Wall Shower with Concealed Supplies
Installation
8/23/2017
Bradley •
215-1855 Rev. A; ECN 17-03-011
Make Electrical Connections
2
A
Install a 120VAC/12V DC
plug in adapter in a remote
location a safe distance from
the shower room .
B
Connect cable from solenoid to TouchTime
module . Connect cable from pushbutton
to TouchTime module . Connect cable
from DC adapter to TouchTime module .
WARNING DO NOT put the 120VAC/12VDC plug in adapter in the shower room. Check local codes and
ordinances for proper location and connection requirements. Conformity to local codes is the
responsibility of the installer.
WARNING DO NOT activate power to your shower until installation is complete.
WARNING Verify that the electrical source to the fixture is 12V DC.
NOTICE: Connection of leads other than shown below may cause permanent damage to the electrodes.
Pushbutton
Cable
Pushbutton
Cable
TouchTime
Module Cable
Activation of the pushbutton takes place only when it
is released, thereby preventing "hold open" activation.
Plug-In
Adapter Cable
TouchTime
Module
Adjusting the TouchTime Module
The TouchTime module is set at the factory with the selector
switch in position 7. This provides a 60 second time out period.
To adjust the TouchTime module to a different time
out period, turn the selector switch to the desired time
out setting (4 through 9 for no flush, A though F for 24
hours flush) as indicated on the module label .
A
The 24 hour flush function will activate water flow for a period of 60 seconds any
time there has been no activation within the past 24 hours. This function is used
to help clear stagnant water from the plumbing system and can provide some
measure of prevention against the formation of bacteria in supply pipes.
3
