background image

2

Bradley TouchTime

®

 Individual Built-In Wall Shower with Concealed Supplies

 Installation

8/23/2017 

Bradley • 

215-1855 Rev. A; ECN 17-03-011

Pre-Installation Information

TouchTime

The 1C TouchTime

®

 Shower controls water flow at each station through the use of a timer module . When the pushbutton is 

pushed, a signal is sent controlling the opening and closing of the fixture's solenoid valve . The valve then delivers water to the 
fixture for a preset length of time of 60 seconds (timing is adjustable on module) .

Recommended showerhead heights

Bradley 1C TouchTime showers can be installed at any height (see 
recommended heights) . 

NOTE: The heights listed are measured from 

finish floor to showerhead tip.

Components

Material:

 All exposed parts are stainless steel or polished chrome-plated brass . 

Supply Inlet:

 The supply inlet to the valve assembly is 1/2" IPS . 

TouchTIme and Solenoid Valve:

 Each TouchTime mechanical pushbutton/piezo switch activates a flow of water . Each nozzle 

is controlled by a separate solenoid valve, allowing each user to activate a flow of tempered water from one spray nozzle with a 
pushbutton or piezo switch for 60 seconds . Each valve uses less than half the maximum amount of hot water allowed by the ANSI/
ASHRAE/IES 90A-1980 Standard . Activation time can be adjusted in the field . 

Solenoid Valve:

 An electronically controlled solenoid valve serves as the metering mechanism . Few moving parts provide reliable 

metering performance and the solenoid is unaffected by chemicals and minerals often present in municipal water supplies .

Supplies Required for Installation

•  1/2" IPS piping and 1/2" IPS tempered water supply piping and fittings (for solenoid)
•  four 1/4"-20 wall anchors for showerhead and two #10 wall anchors for pushbutton assembly
•  Teflon tape or teflon pipe dope
•  110 VAC power source for 12V DC plug in adapter (available from Bradley as an option)
•  OPTIONAL: Bradley recommends installing an electrical cut-off switch to the unit . This feature allows no accidental 

water delivery during regular maintenance and service .

Age

Male

Female

Adult

6' (1 .83m)

5'6" (1 .68m)

Teenage

6' (1 .83m)

5'6" (1 .68m)

Pre-Teen

5'6" (1 .68m)

5'6" (1 .68m)

Содержание TouchTime 1C






Отзывы: