Installation
LD-5010
Bradley
• 215-1869 Rev. B; ECN 17-11-004B
8/24/2017
13
For ease of drain installation, lay the bowl on its back.
1
Drain Assembly
O-Ring
Drain
Adapter
Packing
Washer
#10-24
Screw
Assemble the remaining
components as shown and
thread the four screws through
the drain adapter and into
the basin inserts. Ensure the
screws compress the drain
adapter evenly onto the basin.
A
WashBar Installation
2
Single station shown; 2 station similar.
Assemble WashBar through basin
WashBar holes. Run cables and
tubes on left side only.
B
Secure from underside
with nuts and grounding
washer (right side only).
D
WashBar
Grounding Washer,
.25 QC
Nut, WashBar,
1-3/8-18
Connect grounding wire (supplied by
installer) to grounding washer and
ground per local building code.
C
Position bowl on the
floor, upright, as shown.
A
Soap Tube (Clear), 1/4" Water
Tube, LED Cable (Gray), Soap
Sensor Cable (Shorter Cable) and
Air/Water Cable (Longer Cable)
WashBar comes pre-assembled,
with the exception of the aerator.
Attach flexible PVC dryer
tube to shank using hose
clamp. Tighten to 30-35
in. lbs using 5/16" socket.
E
Attach the 1/4" supply
tube to the 1/4" union
elbow.
F
When attaching flexible
PVC dryer tube, be
sure tube is touching
the WashBar nut when
complete.
NOTICE! Do NOT
overtighten drain
adapter screws.
