Bradford White RE2H50S 1NCWT Series, Инструкция по установке и эксплуатации

Страница: 5 / 28

5
General Information cont.-
About the Control Panel
Displaying Temperature Setpoint
The water heater control will display the
temperature setpoint anytime a button on the
control is pressed. After 30 seconds of
inactivity, the display will go blank. However,
the LED indicating the selected operation mode
will remain lit. To wake the control at any time
to see the temperature setpoint, press any
button on the control.
Turning on the Water Heater
There is no power button for this unit. Once the
water heater is wired and power is supplied, it
will be on. The display will show the current
water temperature setting and an LED will
illuminate, indicating the current operating
mode.
To comply with safety regulations, the controls
are factory preset to 120°F (49°C) and Hybrid
Mode. It is recommended that the unit be set to
Heat Pump (Only) Mode to maximize energy
savings. Operating in Hybrid Mode provides a
balance of energy savings and hot water use
convenience.
Reported energy consumption is based on
operating the unit in Hybrid Mode at required
Department of Energy (DOE) test conditions.
Operating at lower temperature settings or in
Heat Pump (Only) Mode will provide even
greater energy savings.
To Adjust the Temperature
Follow these steps:
1. Press the UP or DOWN arrow on the
control panel keypad to the desired
temperature.
2. Press ENTER to accept the new setting.
Note: To change between °F and °C,
press and hold MODE.
Control Features
Display
Displays the current temperature or the number of days for
vacation mode. To display setpoint if display has gone blank,
press any button.
Operating Modes
(see page 6 for description)
Vacation
(see page 6 for description)
Mode Selector
Press this button to toggle through the various heating modes.
Press and hold to switch between °F and °C.
Arrow Pads
Use these buttons to manually change the water temperature, or
to select days for Vacation Mode.
Enter Key
Use this button to confirm temperature setting following
adjustment.
Filter Reset
The filter is dirty and requires cleaning when the red light is
illuminated. Filter is located on top of the water heater. Press the
button and hold for 5 seconds to reset filter alarm.