IMPORTANT INFORMATION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 1
IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers seat van-
tage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic parts of a vehicles
dash.
WARNING:
Unnecessary force or pressure can cause pieces to crack or break.
PARTS INCLUDED:
MVM-45-05 Mount, 3 - #8x3/4” Self Tapping Screws, 2 - M4x8 Phillips Pan Head Screws, 2 - M4 Nylon Stop
Nuts, PHS-203 Ultra Slim Swivel and Mounting Hardware.
TOOLS NEEDED FOR MVM MODIFICATION
(
if required
)
4 inch Mounted Bench Vise
12 oz. Ball Pein Hammer
Standard Tin Snips
Small File
TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
# 2 Phillips Screwdriver
9/32” Open End Wrench (for swivel)
Marking Pen
DASH DISASSEMBLY INSTRUCTION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Locate and remove three climate control knobs. Note: Pull straight
outwards to release these knobs. Remove the two Phillips screws on the
outside knob controls. Once all three knobs and two screws are removed
and set aside carefully, use the Dash Trim Tool (#SIT-104) to remove the
dash trim bezel. Set the bezel aside carefully.
Skip to
Step 5
on the following page if you have not yet formed the
bracket to fit your vehicle.
Locate and remove two screws from the right of the radio. Set screws
aside in a safe place. Place part “A” of the MVM over existing screw
holes and replace factory screws as shown in middle picture on the left.
When smaller part “A” is secure, reinstall the dash trim bezel in reverse
order securing all clips and screws. Reinstall the screws that secure the
climate control bezel, and also reinstall all three control knobs.
Once dash bezel is secure, connect part “B” to part “A”. Use the two (2)
M4x8 Pan Heads screws provided and Nylon Nuts and tighten part “B”
to part “A” with a 9/32” open end wrench and Phillips screwdriver.
Install the included Ultra Slim Swivel #PHS-203 to your Multi Vehicle
Mount or any other AMPs compatible device.
Your installation is complete
Install Mount Here
1
2
3
Note:
The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.
Outlander Shown
Outlander Shown Above
Lancer Shown
Lancer Shown
Connect A&B
