bq witbox 2, Быстрый старт

Страница: 32 / 36

31
EN
The piece is being printed OK but the edges have started to come
unstuck
This is due to incorrect levelling. If the distance between the extruder nozzle
and the bed is too large, the filament at the ends of the piece will not adhere
properly and will come away. Make sure that auto-levelling is enabled, or
alternatively, you can level the bed manually again.
How can I increase adhesion to the bed?
You can achieve greater adhesion by removing the bed from the machine and
spraying it with 3D printing lacquer or by sticking Fixpad or tape to it. If you
use Fixpad or tape, remember to readjust the offset once you have put the bed
back in place.
Can I pause a print job?
You can pause a print job in progress by pressing the control wheel and selecting
the
Pause option. When you are ready to resume printing, select Resume . If you
switch off the printer, it will not be possible to resume the print job.
Can I stop a print job?
You can stop a print job in progress by pressing the control wheel and selecting
the
Stop option.
The filament has broken inside the Fibonacci guide.
If this occurs, you will need to remove the damage material manually. To do this,
remove the Fibonacci guide from the extruder by applying pressure down onto
the extruder fitting and pulling the guide upwards. This will enable you to access
and remove the damaged filament.
The piece was being printed correctly and the material stopped
coming out
This is due to a knot in the filament reel, which prevents material from entering
the extruder. To prevent this from happening when storing a reel that you have
been using, insert the end of the filament into one of the holes in the plastic reel.
It could also be caused by a filament blockage in the hot-end. See the section on
Use and maintenance of your Witbox 2 to resolve this.