bpr Rotax 912 i Series, Руководство по обслуживанию, Страница: 142 / 458

Effectivity: 912 i Series
Edition 1/Rev. 0
d0
667
2.
fm
MAINTENANCE MANUAL
BRP-Rotax
72-10-00
Page 6
July 01/2012
Fig. 1
Fig. 2
NOTE:
If desired, the optimised special tool
part no. 877540 can be used to re-
move the propeller gearbox.
See Fig. 3.
Fig. 3
DRIVE GEAR - REMOVAL
3 Install puller part no. 877660 onto the two
M8 threaded bolts of the gear cover.
4 The entire propeller gearbox can now be
tapped off with the handle without damag-
ing the ball bearing or propeller shaft.
m
WARNUNG
NOTICE
When removing the propeller gearbox, take
care not to damage the bearing point and the oil
seal running surface (on the roller bearing side)
of the propeller shaft.
1. M8 Allen screw 2. M6 Allen screw
1. Puller part no. 877660 2. Handle
3. Gear cover
Step Procedure
Step Procedure
1 Insert the 8x20 dowel pin into the bore on
the right and left of the gearbox housing.
2 Install M6x40 hex. screw into the pushing
jig assy..
3 Put the pushing jig assy. in the center and
fix it with a M10x20 hex. screw.
4 Using the hex. screw, press the gearbox
housing off from the crankcase simultane-
ously on the right and left.
1. 8x20 dowel pin 2. M10x20 hex. screw
3. M6x40 hex. screw
m
WARNUNG
NOTICE
The gear set has a continuous 6-digit serial
number which is marked on the drive gear and
on the end of the dog gear. The gears are in
pairs and must not be mixed up!
09560
11
2
3