Step
5
-
Install Internai Perlpherals (IDE Devlces)
1 .
Set the required jumpers of ail
IDE
devices according to the
instructions by the manufacturer. (Harddisk and CDROM/DYO drives
have to be set to Master and Slave modes if Vou want to connect
more than one
IDE
device with the same
IDE
connector on the
mainboard. If there are two Masters or two Slaves on one cable,
they will not function.)
2.
Put your
IDE
devices (harddisks, CDROM/DYO drives, etc.) into the
system case.
3.
Connect an
IDE
cable on
the back-panel of each
IDE
device to the
corresponding headers on
the mainboard. Close the
tabs to secure the
connector. Please note
that
IDE
cables are
directional and cannot fit
correctly unless proper1y
oriented.
Important:
You need to use
ATA-1 00 (IDE1 00)
or better cables for
your
IDE
devices. Old
40
wire cables will not work.
4.
Connect an available
power cable to the
backplate of each
peripheral device. Please
note that the power
cable is directional and
will not fit unless
property oriented.
9
