Installation Guide:
1.
Unscrew shoulder washer
from the unit
5.
Optional – Fix shoulder washer to
underside of surface with provided
screws, subject to worktop type
6.
Connect mains plug to power
supply and switch on
7.
Remove protective film
from cover disc by hand
2.
Position flush fit adaptor
into hole
3.
Insert unit into hole
4.
Screw shoulder washer onto
underside of unit and tighten
into place
Steps:
8.
Unit is now ready to use
Before you start
Please ensure:
The worktop is at least 20mm but no greater than
55mm in thickness
Adequate space is available underneath to
accommodate the shoulder washer and enable
access to tighten/clamp
You have room on top for a hole size of
124mm (or 101mm if not using the flush
fit adaptor)
When a suitable location is selected you
have room to cut a 124mm (flush fit)
or 101mm (non-flush fit) dia hole in
the worktop
There will be enough space below for the
unit to fully retract and for the leads to run
unhindered from the base of the unit
Tel:
0844 7766 800
Fax:
01295 678 999
Email:
www.bpfonline.co.uk
SKU: F-03011/2