B4-1KB
B4-1KB
3.
CAUTION :
*
The UPS is designed to power computer loads and the associated
peripheral devices, such as monitors, modems, external H-Disk
drivers, etc. To ensure the performance of the UPS, Do Not load the
UPS with laser printer, motor, or any type of inductive load.
*
Connecting the UPS to a two-pole, three-wire grounding mains
receptacle. Connection with any other type of receptacle may result
in a shock hazard and may violate local electrical codes.
*
Do not allow water or any foreign object to get inside the UPS. And
do not put objects containing liquid on or near the unit.
*
Keep UPS away from fire or heating sources.
*
The UPS is shipped from the factory with fully charged internal
batteries; however, the batteries may lose some energy during
delivery and storage. To ensure that the UPS will provide the
expected run-time during a blackout, the UPS must be left in
charging for at least 5 hours before your first use. The batteries
would be recharged automatically by the UPS when the UPS is
connected with city power.
4.
INSTALLATION, OPERAT ION & AUDIBLE ALARM :
4.1 Installation
*
Inspecting the packing carton for damage that may have occurred while
in transit. Immediately notify the carrier and place of purchase if any
damage is found. Retain the package for future use.
*
Plugging the power cord to a 3-wire grounding receptacle. If an
extension cord must be used between the UPS and the nearest wall
outlet, use a 3-wire grounding type rated for at least 20 Amps.
*
Connecting your equipment to the UPS. To ensure that your
computer equipment will be protected during a utility failure, it is
important to make sure that the maximum power need of the
equipment is not over the rated capacity of the UPS. When
blackout happens, LED of operation status will become red and
alarm will beep if the load is over the rated value. Meantime, if the
overload is severe, the UPS will shut down immediately for
protecting UPS itself.
7. TROUBLE SHOOTING
Problem
Possible Cause
Action to Take
UPS no reaction while
AC is connected
1. Line cord plug is loose
2. Fuse on rear panel blown
(Inside the drawer of inlet)
3. Dead wall socket
1. Check the line cord plug
2. Replace fuse
3. Check wall socket with a
table lamp.
Power output is normal, UPS
emits continuous beep, and
status LED shows RED.
UPS is over loaded
Turn off UPS and unplug
excessive loads from UPS.
UPS does not provide
expected run time
1. Excessive loads connected
at UPS’s outlets.
2. Battery is weak and
cannot provide enough
capacity.
Do not operate the UPS,
and leave the UPS plugged
in for 10 hours. Then, test it
again, if UPS still cannot
provide expected run time,
battery should be replaced.
Button on front panel
doesn’t work
1. The CPU inside UPS is
not running correctly.
2. Button damaged.
1.
Push the button for 6
seconds to reset the UPS.
2.Unplug line cord and all
loads from the UPS, and
call for service.
Under AC mode, UPS emits
urgent beep (8 beeps per
sec.) and replaces battery
LED comes on.
Battery is weak and should
be replaced
Replace batteries.
No output when blackout
happen.
1. Dead battery.
2. UPS NG.
1. Replace battery.
2. Call for service.
5 10
