Electrical safety and cord handling
•
Before installing this equipment, make sure your outlet voltage corresponds to the voltage stated on
the appliance rating label.
•
To prevent contact with high voltage components inside, do not attempt to open the equipment.
•
When connecting the equipment, align the plug properly and insert it fully to prevent electric shock.
•
Only use this equipment with the cord and plug supplied, and do not overload the power outlet.
•
If the power cord is damaged, do not use the equipment. The cord must be replaced by the
manufacturer or similarly qualified personnel in order to avoid a hazard. Contact the after sales support
line for advice.
•
CAUTION
: To reduce the risk of fire or electric shock, do not expose this equipment, the power supply
cord and plug to rain or moisture; do not use it anywhere near water or where water splashes or drips;
do not touch the power plug with wet hands. In the event that water or other liquids enter the device,
unplug the unit immediately and clean and dry it as best as possible. Then have it checked for damage
by a qualified technician. Contact the after sales support line for advice.
•
Do not repair the unit yourself. Only have it serviced by qualified personnel. Contact the after sales
support line for advice.
•
Unplug the unit from the power outlet after use to avoid possible damage during electrical storms, or
when the equipment will be unattended or unused for a long period of time.
•
Do not let the cord hang over the edge of a table or counter, or touch any hot surface. Do not allow
anything to rest on or roll over the power cord, and run any cords so that no one steps on or trips over
them.
•
Do not run the cord near heat-producing appliances such as radiators, stoves or irons. The excessive
heat could melt the insulation and expose live wires.
•
Always grasp the plug, not the cord, when disconnecting the unit. Pulling the cord can damage the
internal wires and may cause a fire.
Installation
•
When installing the unit, make sure to place it:
