Cleaning, maintenance and repair
21
Sprühboy 08s - Airless Edition 02.13
5.3
Cleaning the agent-nozzle
- Secure the spray gun by means of the locking
device (1) against unintended spraying.
- Manually slacken the bayonet cap (2) and
remove.
- Remove the agent-nozzle (3) from the bayonet
cap.
- Clean the agent-nozzle using hot water.
- Blow out the agent nozzle with compressed air or
with the mouth against the direction of flow.
Never clean the nozzle using a tool.
Deformations at the nozzle mouth will
impair the spray pattern.
Never blow out the agent nozzle in the
direction of flow, you will only blow
impurities even deeper into the agent
nozzle.
By holding the agent-nozzle up to the
light, check whether there are still any
particles inside the agent nozzle.
- Re-insert the agent-nozzle into the bayonet cap.
- Screw the bayonet cap back onto the spray gun.
- Replace the spray gun in the spray gun retainer.
Replace the agent nozzle in good time.
Signs of wear (such as rounded edges,
deformations at the nozzle mouth) at the
agent nozzle will impair the spray
pattern.