Push the DIP switch on the remote control to a desired position
(different from the position on the other remote controls that are
paired with other nearby bases) and insert the batteries.
Press and hold the "LINK BUTTON" on the control box untill the
LINK LED lights, then release the "LINK BUTTON", after that, the
LINK LED flashes, now the control box are ready for pairing .
Press and hold simultaneously the Head-Up button and Foot-Up
botton on the remote control untill backlight LED flashes, then
release the two buttons. The backlight LED will keep flashing when
it's searching the control box, once both of backlight LED of remote
and LINK LED of control box stop flashing, the pairing operating is
completed.
Very important: Pairing your device must be completed within 2
minutes; Make sure the other base in the room is powered off;
Stronger suggestion: Please use Sync Cable for operate two bases simultaneously (see page 13), more safer
and higher effect.
Attention: All bases are set to the different DIP of the remote for easier use. You need to pair your remote if you need
one remote controls two bases simultaneously. If using only one base normally, proceed to page 12.
http://www.boydspecialtysleep.com
Remote Pairing
STEP 1:
STEP 2:
STEP 3:
○
○
