Boya BY-WM5, Инструкция по эксплуатации

Страница: 3 / 10

How to use it
Insert batteries in the transmitter and receiver units
1.Both transmitter and receiver requires two LR03/AAA size batteries.
2.Slide and remove the transmitter’s battery compartment cover.
3.Insert two batteries.
4.Close the battery compartment cover.
5.Do the same ways as step 2 to 4 to insert battery into receiver.
Precautionary measures when using batteries
Batteries/power packs, if inappropriately handled, can run out or explode.Please observe
the following notes on safety when handling batteries to be used in this device:
Use only batteries mentiond in these operating instructions.
Do not lay the batteries in a fire and do not expose them to direct heat.
In order to avoid damage to the product you must make sure that you remove the
batteries,if you do not use the product over a longer pe-riod of time or if the batteries
have been discharged.
If battery fluid cones into contact with skin or clothes, rinse it off imme-diately with
fresh water.
Please read these istructions for use thoroughly before you use this new equipment
for the first time.It contains everything you need to know in order to avoid damage to
persons or property.
Strictly follow all notes on safety in these instructions for use.
Keep these instructions for use in a safe place,If you sell you equip-ment or pass
it on to someone else, you should also pass on these instructions for use.
Connecting the transmitter and receiver
Receiver
1.Mount receiver to camera.
2.Insert the straight plug of the connecting cable into the receiver “LINE OUT” jack.
3.Insert the other plug of the connecting cable into camera “MIC” socket.
4.Insert earphone ( the one with speaker) into receiver “ ”.
5.Slider the power ON/OFF switch to ON position ( the LED indicator will light in green)
Transmitter
1.Insert the earphone ( the one without speaker) into transmitter “ ”.
2.Insert the lavalier/lapel microphone into transmitter “ ”.
3.Slider the power ON/OFF switch to ON position ( the LED indicator will light in green).
4.The belt clip on the back of the unit clips the transmitter onto a belt, or the transmitter
simply can be put into a pocket.