Page 11/23
February 2021
FLAIL MOWER | User manual
5.
ADJUSTMENTS
Leveling the Mower
NOTE
: Tractor and mower should be on level ground.
Leveling can be adjusted at the tractor’s 3-point arms and center link.
Cutting Height Adjustment
The machines cutting height depends upon the position of the rear roller.
1.
Remove the bolts that fix the roller on both sides.
2.
Lift or lower both sides of roller in equal measurements.
3.
Replace bolts and re-tighten.
3-Point Hitch Adjustments
The 3-point hitch system on this mower has been designed for front to back flotation when mowing on uneven
terrain. Adjust tractor’s top center link to place the upper hitch pin vertically above or slightly behind the lower hitch
pins. The mower should be run with the back 15 degrees lower than the front.
The hitch can also be adjusted from side to side by turning the adjustment handle. Turn handle until you have
achieved your desired location.
CAUTION
Engage parking brake, shut off tractor, remove key and disengage PTO before making any height adjustments!
Belt Tension
CAUTION
Belt drive system under spring tension; use care to avoid bodily harm!
The Belt tension should be checked after the first 20 hours of use. And then every 40 hours of use.
1.
Tension on the belt can be adjusted with the belt tension bolt. Turn the bolt until desired tension is achieved.
When the belt has the correct tension the gearbox should be adjusted so that the gearbox extension is running
straight (parallel) with the flail mower. Loosen bolts at the bottom of the gearbox and move gearbox until
gearbox extension is running straight.
2.
Excessive tension on the belt may lead to premature failure of belt and drive components.
CAUTION
Excessive tension on the belt may lead to premature failure of belt and drive components. Excessive tension on the
belt may also lead to a safety hazard to the operator or bystanders.
