BOX tracker
Communication Protocol v1.5
30 of 36
6.49
UPLOADD
On Vehicle trackers this defines distance in km between each upload event. The accrued distance
travelled is reset each time any upload event occurs. If this parameter is set to zero then upload is not
initiated on distance travelled.
E.g.
UPLOADD,7
Default value:
0 (off)
6.50
UPLOADHC
On Vehicle trackers this causes the unit to upload on the angle entered using the command GPSHC.
E.g.
UPLOADD,7200
Default value:
0 (Do not upload on heading change)
Range:
0 & 1
6.51
VALIDATE_KEY
This feature is used in conjunction with the immobiliser & addkey functions
0 = Do not validate key. (default)
Any Ibutton Key presented to the reader is accepted as valid and the immobiliser is disabled allowing
the vehicle to start.
1 = validate key
Any Ibutton Key presented to the reader is looked up in the stored “keys” file. If the key is not present in
the file then the key is rejected (buzzer sounds for 1 second if fitted & enabled) and the immobiliser is
not disabled.
E.g.
All keys must be validated before immobiliser is deactivated
VALIDATE_KEY,1
See Also IMMOBILISER, IMMOB, ADDKEY, DELKEY,
6.52
VBAT12
To accurately detect when the external battery is low the tracker needs to know the normally external
supply voltage. Setting to 1 indicates 12 volts and 0 indicates 24 volts.
This command does “not” affect or configure the trackers operating voltage range (which is 9 to 36
volts), it only affects the voltage level where event codes 35 (Power Failed), 36 (Power Low) ,28 (Power
On) and 29 (Power Off) are logged. This threshold being lower for 12 volt supplies than 24 volt supplies.
Содержание BOX tracker
Страница 1: ...Communication Protocol v1 5 ...
