© Audio Trade GmbH · Pro-Ject Tuner Box S · Revision 2011.12.01
4
Auto scan function
Long press
0
M4
starts,
0
M1
confirms the auto scan function.
0
M1
clears the complete memory while
scanning.
0
M2
keeps stations with good signal strength in the memory and overwrites stations with
insufficient signal level while scanning.
Using the Pro-Ject Tuner Box S
Tuner Box S
To switch on from standby or to standby
The button on the left hand side will toggle the tuner between its fully operational status and standby. The
blue LED on the front panel shows that the unit is powered on.
If the Tuner Box S is connected to the remote switch-on facility of a Pro-Ject pre amplifier Pre Box S, then
choosing input 1 at the pre amplifier will switch the tuner on. Selecting a different input will switch the tuner off.
Dimming the display, setting the colour of the des display
Press (approx. 3 seconds) to enter the set-up menu.
TUNE
and
TUNE
will change the display brightness. The following settings are available: „
display off
“,
DIM 1
-
DIM 4
and
DIM MAX
.
0
M3
decreases
0
M6
increases red
0
M4
decreases
0
M7
increases green
0
M5
decreases
0
M8
increases blue
The changes will be shown in the first line of the display. After leaving the set-op menu, the changes will
become valid for the complete display.
0
M1
loads the factory settings for brightness and colour. To leave the set-up menu press
0
OK
.
Содержание PRO-JECT TUNER BOX S
Страница 1: ...INSTRUCTIONS FOR USE Pro Ject Tuner Box S ...
