BOWMAN SUPERMATCH 6/8 ABT, Инструкция по эксплуатации

Страница: 4 / 12

04
Adjusting clay knife separators
We set the knife height at the factory to accommodate standard clays, if you need to alter the height please follow
the written and photographic instructions. The knife separators height can be adjusted by using 2 x 10mm
spanners. The stainless steel knife should clear the rim of the clay by 0.5mm to operate correctly. To adjust the
height, loosen the locking nut, turn the bolt head clockwise to lower and anti
- clockwise to raise the knife blades.
Once the correct height is achieved re - tighten the locking nut. The knives should ideally clear the driving band of
the clay by 3mm thus not damaging the clay in any way.
Electric Box
The motor is protected by either a fuse or circuit breaker housed in the control box. If the fuse is activated it can
easily be replaced. Two spare fuses are supplied in the control box. If the circuit breaker is activated the Thermal
Overload reset button will pop up to cut the power.
Before replacing the fuse or pressing the Thermal
Overload reset button to re - activate the trap you must turn the 3 position switch to off and disconnect the
battery to investigate the reason for the malfunction . Most commonly this is because of a flat battery or the
throwing arm is jammed. Please be aware the throwing arm may be parked in a dangerous position so be
careful not to place yourself in harms way while you investigate or when you re - activate the trap.
0.5mm
Jacking screw
BOLT HEAD
Locking nut
Pic 1
Jacking screws
3mm
Pic 2
Adjusting advance and retard limit switch
The Limit Switch is set to stop the throwing arm just before it goes
‘ over centre ’ and fires. We set this at the factory however if the arm
stops too far from the clay or too close to the centre causing ‘ auto fir-
ing ’, please follow these instructions to re - set it. “ Disarm and Make
Safe Procedure ” should be followed. This includes removing the bat-
tery leads so that, with the arm visible to the left, it is safe to adjust the
limit switch ring.
Unlock by using a 6mm allen key. Standing in front of the trap and viewing from the top, rotate the ring clockwise
in small increments to stop the arm further away from the clay and anti
- clockwise to stop the arm closer to the
clay. Re - lock the ring and move to a safe position behind the trap. On/run the trap to test the arm position and re -
adjust if necessary using the same procedure.