Esprit 2 125 230V Operating Instructions.
Esprit 2 125 230V Operating Instructions.
6
3
14. Operation
•
Switch the unit ON, plug in the sync cord and connect to camera shutter at ‘x’
synchronisation. Alternatively, plug in Infra Red Receiver or Omnicell. Switch ON and
select modelling lamp ON or OFF and flash power required. When the unit is ready to
fire the green LED (Fig.2. 3) will light. Press Open Flash Pushbutton (Fig.2. 5) and
check that the unit operates correctly. The open flash button should also be pressed
after the flash power setting has been reduced, to ensure that the next flash is of the
required power.
15. Mounting
•
Mount the Esprit 2 125 unit on selected support system. The mounting bush on the ‘L’
bracket allows for two possible ways of mounting to the stand / support (Fig.4). Method
B may be found useful if the light is required to point down.
1. General
Welcome to the world-wide family of Bowens flash equipment users, and
congratulations on selecting the Esprit 2 125. The Esprit 2 125 has been designed
using the latest technology, to produce a unit that is very simple to operate, small in
size and weight, yet has a powerful output.
2. Safety Notes
•
The Esprit 2 125 must not be used in an environment where moisture or flammable
vapour is likely to come in contact with the unit.
•
A fire hazard exists if flammable materials are placed in close proximity to either the
flashtube or modelling bulb when the unit is in use.
•
The charging and modelling circuitry of the Esprit 2 125 is protected by a 5A 20mm fuse
mounted on the rear panel (Fig.1. 1). Disconnect the supply before changing the fuse.
Never
replace with a fuse of a different rating. A spare 5A fuse is fitted in the fuse
holder.
•
Switch off and disconnect supply before changing fuse, modelling bulb or flashtube.
•
Do not restrict slots in case when in use.
•
Care must be exercised when handling equipment that has been in use. The reflector
and front end of the unit can become
Very Hot
.
•
Due to the high voltage / high energy used in Esprit 2 125, all servicing must be carried
out by an authorised Service Centre.
3. Contents Of Carton
•
Esprit 2 125 230V with flashtube
•
Sync.
cord
•
Instructions
4. Fitting the Modelling Lamp
•
Switch off and disconnect from supply. Screw modelling lamp into ES lampholder in
the centre of the reflector.
•
Note
: It is recommended that a Photoflood or Halostar bulb with a maximum wattage
of 275W is not exceeded for the Esprit 2 125 unit. The manufacturer will not accept
liability on the use of any lamp with a greater wattage than 275W.
5. Power Supply Connections
•
230V AC 50Hz
Use the mains lead supplied to connect to the mains supply.
6. Mains On/Off Switch
•
The green illuminated On/Off switch (Fig.1. 5) on the rear panel controls the power to
both the flash and the modelling lamp. Setting the switch to 1 turns the unit ON and 0
turns the unit OFF.
Fig.4
