INSTRUCTIONS
6
2
INSTALLATION
1. Select location for the console and switch-box
that is in easy access and in clear view of the
operator. Ensure that the console and switch-
box will be free of moisture, direct sun, and
excessive vibration.
2. Use the provided large ball and socket to
mount the X35 console.
3. Use the provided small ball and socket to
mount the in-cab keypad.
4. Make the following harness connections:
a. Connect
X35 harness
(3151-45) to the
back of the X35 monitor, refer to
Figure
??
.
b. Connect
Power
connector on X35 main
harness (3151-45) to power auxiliary
adapter (3151-69) and connect to 3-pin
AMP auxiliary power connection in the cab
(if exists).
c. If the auxiliary power connection does not
exists in the cab, connect
Power
connector
on X35 main harness (3151-45) to power
battery adapter (3151-68) and route to
battery and switched power source.
d. Connect
RS232-D
connector on X35 main
harness (3151-45) to GPS receiver using
appropriate adapter harness.
e. Connect in-cab switchbox harness (3132-
41) into the back of in-cab switch box.
Connect other end to switchbox ISOBUS
adapter harness (3132-42).
f. Connect ISO extension on switchbox
ISOBUS adapter harness (3132-42) to ISO
loop A on X35 harness (3151-45). Connect
other ISO extension on switchbox ISOBUS
adapter harness (3132-42) to ISO loop A
on ISOBUS X35 harness (3151-78).
g. Connect ISO loop B connectors together
on ISOBUS X35 harness (3151-78) and
the X35 harness (3151-45).
h. Connect the switched power lead on
ISOBUS X35 harness (3151-78) to
connector on X35 harness (3151-45).
Connect other lead from ISOBUS X35
harness (3151-78) to SwitchBox power
extension harness (3132-76), then connect
that to switchbox harness (3132-42).
i. Connect the ends labelled "12V Power/
Relay" from 3132-87 & 3132-88 to the
relay 3132-89. Also connect the end
"Power Relay Coil" from 3132-88 to the
3132-89 relay. Install the heat shrink over
the area to protect the exposed wires/posts,
refer to
Figure 13
.
j. Mount the relay near the battery where it
will be protected and the contacts will not
be shorted.
k. Connect the end labelled 12V Battery "+"
from 3132-87 to positive battery terminal.
l. Connect the end labelled Battery/Frame
Ground from 3132-88 to the negative
battery terminal. Route the other end to the
hitch point and mount using mount plate
(5210-65).
m. Connect ends of ISOBUS X35 harness
(3151-78) to battery. Route other end to
hitch point and mount using plate #5210-
65.
