I. SUPPLIES NEEDED
• A Nail
• a Nickel
• A large screwdriver or other large metal object • a Dime
• A newer zinc penny (dated after 1982)
• a Quarter
II. POSITION THE DETECTOR
a. Have a friend hold the detector, with the
coil raised up off the ground. If testing
alone, place the detector on a table,
with the searchcoil hanging over the edge.
b. Keep the searchcoil away from
walls, floors, and metal objects.
c. Remove watches, rings, jewelry and all
metal objects from hands and wrists.
d. Position searchcoil parallel to the ground.
III. POWER UP
a. Click the MODE control on to the ALL METAL
position.
b. Turn the SENSITIVITY control to the 2:00 position.
c. Keep the GROUND control at NORMAL.
d. Turn DISCRIMINATION knob to low.
IV. SWEEP OBJECTS OVER THE SEARCHCOIL
a. Sweep all objects over the searchcoil.
b. Sweep coins with flat surface parallel to coil.
This is how you will find them buried in the ground.
c. Notice that all objects induce the same tone.
All Metal are detected.
d. Objects must be in motion
over the coil to be detected.
V. TONE MODE
a. Click the MODE control to TONE.
b. Turn the DISCRIMINATE knob to the 3:00 position.
c. Sweep all objects over the searchcoil.
1. Notice the different tones for different objects.
2. Notice no tone for ferrous objects
VI. DISCRIMINATION MODE
a. Click the MODE control to DISC.
b. Sweep all objects over the searchcoil.
c. Move the DISCRIMINATE knob to
different positions for each object.
Move between low and high.
d. Notice the different tones for different objects.
e. Notice that some objects can be
completely eliminated with the
DISCRIMINATION control knob.
5
QUICK-START DEMO
Tracker2.qx_MTK2-Tracker2manual 4/17/15 4:33 PM Page 11