33591-1-0414
Page 5
Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling
logs, wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if
the logs are not properly and firmly positioned in the appliance.
Refer to Figure 1 for the following warning.
Warning:
Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved
with this appliance may result in property damage or personal injury.
A
B
C
D
E
Log Placement - Figure 1
LOG PLACEMENT
Attention:
Refer to Page 4 Parts List and Parts View to order logs
for your appropriate model number.
Glowing embers should be dime-sized pieces that are fluffed up
prior to placement onto the burner. A single layer of glowing embers
is sufficient; do not over-apply.
NOTE: Once the installation is complete with the log set and glowing
embers in place, operate the fireplace to verify flame appearance.
If there are flames directly impinging a log, turn off fireplace, then
remove the glowing ember material directly below where the flame
impingement occurred. This should eliminate sooting on the log,
and provide a more pleasing flame appearance.
Replacement of glowing embers must be purchased from Empire
Comfort Systems, Inc. Application of excess glowing embers may
adversely affect performance of the heater. WARNING: All previously
applied loose material must be removed prior to reapplication.
Replacement glowing embers Part Number
LS41TDF
15999
PLACE GLOWING EMBERS (ROCK WOOL)
IN SHADED AREA ONLY.
FRONT VIEW - COMPLETED LOG SET INSTALLATION (WITHOUT EMBERS)