Questions? [email protected] / 1-800-268-2524
(G)
Metal Base (1pc)
3
(H)
Pipe Cover (1pc)
(I)
Stand Tube (1pc)
(J)
Set screws (2pcs +2pcs s
e
par
at
ed)
(K)
Socket Ring (1pc)
(L)
Middle Tube (1pc)
(M)
Curved Tube (1pc)
(N)
Lamp Holder (1pc)
(O)
Rattan Shade (1pc)
PRE-ASSEMBLY
•
Before starting the installation, shut off the power supply at the electrical panel by switching off the circuit breaker
or removing the appropriate fuse. Cutting the power at the light switch is not sufficient to prevent electrical shock.
•
Remove all parts and hardware from box along with any plastic protective packaging.
•
Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or
hardware.
TO ASSEMBLE
1.
Tear off the double-sided tape on the Load Base
(E). Insert the Large Hex Nut (B) with Spring Washer (C) and
Metal Washer
(D) into the bottom threaded hole of the Load Base (E), Metal Flat Washer (F), Metal Base
(G),
Pipe Cover
(H) and Stand Tube
(I). Rotate the Large Hex Nut (B) clockwise using
the
Wrench (A) until tight.
Please
see Fig.A1.
2.
Rotate the Middle Tube (L) clockwise on to the Curved Tube
(M) until tight. Please see Fig.A2.
3.
Loosen the Set Screws
(J) from
the
Middle Tube
(L) using
the
Cross screwdriver. Please see Fig.A3.
4.
Insert the Middle Tube
(L) into the Stand Tube
(I)
, a
ligning the screw holes on
the
Middle Tube
(L) with the
holes on
the
Stand
Tube
(I). Tighten the Set Screws
(J) into the holes
with the
Cross screwdriver. Please see
Fig.A4.
5.
Unscrew the Socket Ring
(K) from
the
Lamp Holder
(N). Please see Fig.A5.
6.
Attach the Rattan Shade
(O) onto the Lamp Holder (N), then secure the Rattan Shade
(O) by tightening the
Socket
Ring (K).
Insert the specified light bulb into the
Lamp Holder (N). Please see Fig.A6.
LAMP CARE INSTRUCTIONS
Wipe clean with a soft, dry cloth or static duster.
Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the fixture’s
finish.
