Botex Smart Director 256, Руководство пользователя

Страница: 22 / 28

2. Operation Guide 2. Operation Guide
2.4.4 Modify steps of a Memory 2.5 Playback one or more Chases or Memories
20 19
3 6. Tap Record button, all LED's shall flash briefly three
times indicating you've changed fade time of the step.
RECORD
7. Tap Blackout button, then you can continue steps 2-6
to change fade time of other steps.
2.5 Playback one or more Chases or Memories
CHASE
1. Apply power on, tap Chase button causing its LED
to light or flash, the Segment Display shows "ST00".
3
CHASE 1-40
2. When Chase LED is lit, only one Chase or Memory
can be selected. Tap one of Chase 1-40 or Memory
1-8 buttons containing scenes, its LED shall be lit
indicating the chase or memory is playing.
3
CHASE 1-40
3. When Chase LED flashes, two or more Chases or
Memories can be selected at a time. If you select
several Chases or Memories, these Chases or
Memories shall be sequential in the order you
select.
2.6 Audio Chase/Memory
3
AUDIO/DEL
1. When the chase or memory is playing, you may tap
AUDIO/DEL button, its LED is lit, which refers to that
Audio mode is active, the chase or memory shall be
subject to the audio signal detected by built-in Mic.
2. Tap AUDIO/DEL button again causing its LED to go
out, the chase or memory will not be activated by the
audio signal.
2.7 Send Record Data
9 10 11 12
1. You must set up proper DMX connection between two
unit before you can send or receive record data.
2. Turn the power off. While pressing buttons 9, 10, 11,
and 12, turn the power on. If the content of this unit is
empty, the Segment Display shall show "EMPT" . If the
content contains scenes or chases, the Segment
Display shall show "OUT", which means this unit is
ready to send record data.