Receive Mode:
MIDI channel setting
This setting allows you to select MIDI input channel from 01 to 16. While in
Receive mode, press and release MENU several times until "CH" followed by
two numbers from 01-16 is displayed in the LED Display. Then use UP and
DOWN to select MIDI input channel.
Use the MODE to access Receive mode, the LED near Receive is lit indicating
your selection and the LED Display shows "CH" followed by two numbers from
01-16. This mode allows you to use your unit as a four channel DMX/ MIDI pack.
You may also set your unit to function as a 1 or 4 channel pack. To change
between Separate and Parallel mode:
1. Press and hold down the MODE button.
2. While holding down the MODE button, tap the MENU button, the LED near
Parallel will be lit indicating this unit will be used as a single channel pack
and the output of four channel will be controlled by one channel.
3. Repeat steps 1 & 2, the LED near parallel will go out, this unit will shift to
Separate mode(4 channel pack).
Note Number setting
This setting allows you to select starting MIDI Note Number to trigger this MIDI
pack. Any MIDI device is required to send 21 Note Numbers to control the pack.
Note Numbers 1-4(velocity) control the intensity of the four individual channel.
Note Numbers 5-20 turn ON/OFF the programs 01-16 respectively, and the
Velocities control the master level of the programs. Note Number 21 adjusts the
chase speed of the program.
While in Receive mode, press MENU to scroll to Note Number mode, the LED
Display will show "N" followed by three numbers 001-128 indicating your selection.
Use UP and DOWN to select desired Note Number.
Normal MIDI/ F36 mode
While in Receive mode, press MENU to scroll to Normal MIDI or F36 mode, "Nor"
in the LED Display represents Normal MIDI and "F36" will display in F36 mode.
Use UP or DOWN to change between these two mode.
Multi-Pak Instruction Manual Page 8
