Botex DMX DC-136, Руководство пользователя

Страница: 16 / 36

7 Operating
7.1 Assignment of DMX channels to the joystick
In order to control pan and tilt channels of a device with the joystick, these channels
must be assigned to each fixture.
1.
Keep [SETUP] pressed for about 5 seconds until the display changes.
2.
Press [DOWN] to highlight the menu item ‘Assign CH’ . Then press [RECORD] .
ð
The display shows ‘Channel01>Out01’ .
3.
Use the Fixture buttons to select the devices whose channels you want to
assign.
4. Press [UP] until the display shows ‘PAN > NONE’ . Now use [DOWN] to select the
channel that controls the rotation (pan) of the device (for instance
‘PAN>CH01’ ). Press [UP] . Now you can use [DOWN] to assign the corresponding
channel for the inclination (tilt).
5.
If your device has fine tuning channels for pan and tilt, you can specify them by
repeating steps 3 and 4. The display shows ‘PAN FINE’ or ‘TILT FINE’ .
6. To complete the assignment, press [RECORD] .
ð
For confirmation, all LEDs light up briefly.
7. Press [ESC] twice to quit the menu.
7.2 Recording a scene of chase.
7.2.1 Recording a scene
1.
To activate the recording mode, keep [RECORD] pressed for about 5 seconds
pressed.
ð
The corresponding LED lights.
The display shows:
2.
Press [PAGE] (on the left side) so that the corresponding LED is lit. Use [UP] and
[DOWN] to select the corresponding ‘PAGE’ to save the scene to. A total of
twelve pages are available.
Operating
16
DMX DC-136
DMX controller