8 / 23
6.) Press and hold down the
PROGRAM
button for approximately 2 seconds or until the
PROG
indicator in the display stops flashing. A flashing
BLACKOUT
indicator in the display confirms
that the controller is out of program mode.
3.2. Assign Joystick Reverse (PAN / TILT invert)
1.) Press and hold down the
PROGRAM
button for approximately 2 seconds or until the
PROG
indicator in the display flashes. Once the indicator is flashing, record mode is engaged and
you may release the Program mode.
2.) Press and hold down the
MODE
button and then tap the
Fine
button. The
Assign
and
Pan
LEDs illuminate.
3.) Once again, press and hold down the
MODE
button and then tap the
FINE
button. The
REVERSE
LED should illuminate.
4.) Select the fixtures that you wish to assign the
PAN reverse
and
TILT reverse
for by pressing
the
FIXTURES buttons 1-12
, so the selected fixture LEDs illuminate. Ideally, you should
assign opposite fixtures for PAN / TILT reverse. For example, fixtures 1,3,5,7,…should be
assigned normal as describes in the previous section and fixtures 2,4,6,…, should be
assigned reversed so that when moving the joystick around, fixtures movements are reversed
from one another. This feature is normally referred to as PAN/TILT invert.
5.) Press the
TAP / DISP
button to switch between
PL.XX
,
PH.XX. PL.XX
represents the low
byte or fine channel, generally listed as the PAN fine channel and
PH.XX
represents the high
byte or coarse channel, generally listed as the PAN fine channel. Set it to
PH.XX
and press
and hold down the
MODE
button and then tap the
SCENE
button that corresponds to the
PAN channel of your fixture. For example if your fixtures PAN channel is 1 then you did press
the
SCENE 1
button. Please refer to the fixtures DMX chart. If your fixture includes a PAN
fine channel, press the
TAP / DISP
button so the display reads
PL.XX
. Press and hold down
the
MODE
button and then tap the
SCENE
button that corresponds to the PAN fine channel
of your fixture. For example, if your fixtures PAN fine channel is 2 then you’d press the
SCENE 2
button.
6.) Press the
BANK UP
or
BANK DOWN
buttons to switch between
TL:XX
and
TH.XX
.
TL:XX
represents the low byte or fine channel, generally listed as the TILT fine channel and
TH.XX
represents the high byte or coarse channel, generally listed as the TILT channel. Set it to
TH.XX
and press and hold down the
MODE
button and then tap the
SCENE
button that
corresponds to the TILT channel of your fixture. For example, if your fixtures TILT channel is
3 then you did press the
SCENE 3
button. Please refer to the fixtures DMX chart. If your
fixture includes a TILT fine channel press the
Tap / Disp
button so the display reads
TL.XX
.
Press and hold down the
MODE
button and then tap the
SCENE
button that corresponds to
the
TILT
fine channel of your fixture. For example, if your fixtures PAN fine channel is 2 then
you did press the
SCENE 4
button.
