c
Place the air pump on a stable surface outside the reservoir.
Air pump should be placed above level of solution to prevent back
siphon if power fails. Place one airstone on either side of the pump
in the reservoir.
d
Slide the cord guide cover into place adjusting the power cords,
and air lines to allow the cover to insert fully into position.
*Note: Make sure the water level marks are in the appropriate position.
7. Finish the assembly
a
Insert 1 neoprene into each hole in the clone tray.
b
Place the tray onto the reservoir.
8. Move the unit to desired location, and fill reservoir to 1” above the
pump housing
.
Note: Never plug in water pump unless fully submerged under water.
9. Place clone tray on top of reservoir.
10. At this time your Power Cloner is assembled and ready to use.
6c
6d
7a
air pump
tube
airstones
Содержание POWER CLONER 180
Страница 1: ...INSTRUCTIONS 45 77 180 POWER CLONER...