Bosworth Guzzler G2-0503N, Руководство оператора

Страница: 9 / 10

Changing Pump Valves
The Bosworth Company
Doc M-09-33-111516
Each pump body in the Guzzler G2 SapPuller pump features a pair of
valves (a total of 4 for the pump). A valve is fastened between the
pump body and each of its inlet and outlet ports.
(Figure 14)
Valves are typically replaced in pairs; i.e., the inlet and outlet valve
of a given pump body are replaced at the same
Ɵ me.
When replacing a pair of pump valves, it is best that
only one valve
is removed and replaced before a Ʃ emp Ɵ ng to remove and replace
the other valve.
Removing the Valve
1. Disconnect the power.
2. Place the pump assembly with the motor
in a ver Ɵ cal posi Ɵ on.
3. Remove the inlet manifold by loosening
the hose clamps holding the manifold to
the pump fl anges.
4. Remove the 6 screws holding the inlet
fl ange to the pump body. (Figure 15) The umbrella
valve is located between this fl ange and the pump
body.
Note the orienta Ɵ on of
the umbrella valve. The
valve stem points oppo-
site to the direc Ɵ on of
fl uid fl ow. (Figure 16)
Umbrella valve stem points in opposite direc Ɵ on to fl uid fl ow.
Figure 16
8
Loca Ɵ on of inlet and outlet valves on pump
body
Figure 14
Remove 6 screws holding fl ange to pump body.
Figure 15