For your safety, read this manual carefully prior to operating your hose cutting machine.
LIMITED SAFETY WARNINGS
:
WARNING!
Before starting or operating this machine, comply with these limited safety
instructions.
1.
Operate this cutting machine in a well-ventilated area.
2.
Never allow fingers or hands near any moving blade or part of this machine.
3.
Avoid the use of this machine in a dangerous environment.
4.
Keep work area well lit, clean, and free of any obstructions.
5.
Remove all tools from machine before starting and operating.
6.
To avoid accidental starting of hose cutting machine, disconnect power supply before maintenance, servicing,
set-ups, and when machine is not in operation.
7.
Use the hose support pins to create proper bend in hose and to safely assist in holding the hose in place while
performing the cut.
8.
Never modify the plug in any way. Do not use adapter plugs. Outlet should be properly installed and
grounded in accordance with all codes and ordinances. This tool is double insulated and is equipped with a
polarized plug.
9.
Replace damaged cords immediately.
10.
If blade becomes hot and distorts, allow blade to cool completely. Replace or re-sharpen the blade. Abused
blades are dangerous and can anneal, become brittle, and chip.
11.
DO NOT operate this machine while under the influence of drugs, alcohol or medication.
12.
Avoid cutting hose near flammable liquids, gases, or dust as power tools can create sparks and may cause
ignition.
13.
DO NOT expose this machine to rain or wet conditions.
ELECTRICAL DATA
T-71
Specifications
:
Unit is equipped with a 4.5 hp/
115volt 20 amp 1ph -60 cycle motor
(For safety and high performance, we recommend a dedicated 20-amp. circuit)
No load speed = 3,500 rpm
Approximate Weight: 85 lbs.
MOUNTING THE T-71 HOSE CUTTING MACHINE
Mount this cutting machine, using the four bolt and nut assemblies included with the hose-cutting machine, at a
comfortable level approximately 34” from floor. This unit should be securely mounted on a surface that cannot tip.
For proper cutting clearance, the front of the machine base should be flush with the edge of the mounting surface.
Allow for clearance on both sides of the unit for cutting larger bore hoses. The machine must be firmly bolted to a
bench or stand. Cutting machine must be placed within the power cord’s reach. Only use a separate properly
grounded, 20 amp. rated power source. DO NOT use any type of extension cord to operate machine. (
s
ee Fig. #1
)
Содержание T-71
Страница 4: ...Figure 3 Figure 4 Figure 5 ...
