Bravo Assembly Instructions:
This configuration is compatible with Models: Bravo II
and Bravo.
Hardware:
(Per Speaker Stand)
Speaker
Screw
(long) x 2
Threaded
Machine
Screw x 3
P4FL
Base x 1
P4FL
Vertical
Post x 1
•Pliers
•Flat head
Screwdriver
•Phillips head
Screwdriver
Split Washer
(large)
x 2
1
⁄
4
"-20
Threaded
Nut x 2
Split Washer
(small) x 3
Hole Plug
x 3
Step One: Attach Base
Attach the base to the vertical
post with the three included
threaded machine screws and
split washers (small) using a
Phillips head screwdriver. The
post has already been threaded
to ease screw installation. Attach
rubber feet to base.
Step Two: Speaker Wire
With the stand still inverted, route
the speaker wire through the open-
ing in bottom of the base, down
through, and out the opening in
the post. Leave several extra inches
of speaker wire exposed to ease
connection with the Bravo speaker.
Step Three: Mounting the Bravo Speaker
1.
Using the speaker screws (long), washer, and
1
⁄
4
"-20 threaded
nut, mount the Bravo mounting bracket to the P4FL post.
2.
Remove the speaker’s grille by grasping the back of the
cabinet in one hand, while gently pulling the grille away with
the other hand.
3.
Connect the speaker wire to the terminals on the Bravo speaker.
4.
Align the openings in the back of the speaker with the two
posts protruding from the bracket as shown and attach the
speaker to the bracket by inserting the supplied screws
through the holes in the front of the speaker and into the
bracket as shown.
Note: For detailed instructions on installing the speaker to the wall bracket,
please refer to the Bravo owners manual.
5. Insert the three hole plugs in the unused mounting holes on
the back of the P4FL post.
6.
Take up any slack in the speaker wire by
gently
pulling the wire
at the opening in the base.
Required Tools:
(not included)
