Hold the
setup
button on the remote
control for about three seconds, until the
LED on the remote blinks twice.
Enter the three-digit code for your particu-
lar device. The LED on the remote will blink
once after the first two numbers are
entered, and twice after the last number is
entered to signify it has accepted the pro-
gramming. Example: 1 (blink), 2 (blink), 3
(blink-blink). A single long blink indicates
an invalid key sequence.
Test the remote control on your device by
pressing
power
on or off.
If the remote does not appear to be working,
check that the right code was programmed.
Many manufacturers have multiple codes for
different devices; if the first code doesn’t
work, try a different code. Make sure the LED
on the remote blinks every time a button is
pressed. If not, be certain the batteries are cor-
rectly installed or replace the batteries in the
remote control.
Button Reassignment to Control
Different Devices
You might have two devices that would be
controlled by the same button (a VCR and a
DVD, for example, each controlled by the
VCR
button, or a cable box and DSS, each con-
trolled by the
cable
button). In that case, you
will have to reassign one of the other buttons
to control that device.
Example: If you have a VCR and DVD player,
you will need to reassign the
cable
button to
control the DVD player
Press
setup
Press 992 on the numeric keypad
Press the source button (in this example,
the
VCR
button)
Press the destination button (in this
example, the
cable
button)
The
cable
button is now another
VCR
button,
which can be used to control a DVD player.
Program the remote as described in steps 1-4.
19
VOL-
VOL+
CH +
CH -
MUTE
VCR
TV
cable
powe
r
setup
power
Bosto
n
enter
previous
rew
paus
play
stop
fast fwd
record
VC
5-ch / 2-ch
test tone
L front
R front
center
L R
subwoofer
Audio
DVD/night
DSS/night
pause
R
rear
rear
•
2
•
3
•
4
•
5
•
6
•
8
•
7
•
5
•
6
•
7
•
8
DT7000 Manual 11/99 rev2 11/24/99 12:19 PM Page 19
