6
Installation
1. Make a 6
3
⁄
4
" (172mm) cutout using the supplied
template. It is not necessary to remove fiberglass
insulation that may be behind the wall.
2. Run the wire from the amplifier to the cutout. Allow an extra foot of wire at the cutout. Strip
1
⁄
2
"
(12mm) of insulation off the wire, and tightly twist the wire strands together.
3. Remove the speaker grille. Carefully pry on one side with an awl or a small screwdriver.
4. For wall installation, use the cable clamp
supplied to secure the speaker wire to the
housing. (This clamp is optional in ceiling
installations.) Affix the clamp to one of the
screws used to hold the terminal strip to
the housing.
utility knife
Attach the wires to the terminals
cable clamp
Cut a 6
3
⁄
4
" hole.
