-4-
MIII TOOL SPECIFICATIONS
OPERATION
All dimentions in inches unless otherwise specified
FASTENER SPECIFICATIONS:
TOOL AIR FITTING:
This tool uses a 3/8” N.P.T. male plug. The inside diameter should be .275” (7mm) or larger. The fitting
must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 90 p.s.i.g. (4.9 to 6.3 kg/cm2). Select the operating pressure within this range for best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The MIII requires 4.2 cubic feet per minute (221 liters per minute) of free air to operate at the
rate of 60 fasteners per minute, at 80 p.s.i. (5.6 kg/cm2). Take the actual rate at which the tool will be run
to determine the amount of air required. For instance, if your fastener usage averages 30 fasteners per
minute, you need 50% of the tool’s c.f.m. of free air which is required to operate the tool at 60 fasteners
per minute.
MODEL
LENGTH
HEIGHT
WIDTH
WEIGHT
MIIIFS
17-1/4” (438mm)
11-1/2” (292mm)
3-1/8” (80mm)
11.2lbs (5.1kg)
MIIIFN
17-1/4” (438mm)
11-1/2” (292mm)
3-1/8” (80mm)
11.2lbs (5.1kg)
MODEL
FASTENER
CROWN WIDTH
WIRE SIZE
MAX LENGTH
MIIIFS
BCS1500
1/2” (13mm)
15-1/2 Ga.
2” (50mm)
MIIIFN
FLN-200
-
-
2” (50mm)
Caution Regarding Use of this Tool to Install Pre-finished Flooring
This MarkIII Flooring Tool was designed for use in installing unfinished hardwood flooring. It can be used to
install pre-finished flooring however caution must be used to ensure that the finish is not damaged by the tool.
It is recommended that the tool be tested on a sample section to be certain that the tool and technique of use
do not leave marks on the finish. This procedure should be followed before each job due to variations in flooring
and tool condition.
