ENglISh
10
Fig. F
Preparing the Tool
WARNING: NEVER
spray or in any other way apply
lubricants or cleaning solvents inside the tool. This can
seriously affect the life and performance of the tool.
NOTE:
The battery pack is not fully charged out of the
carton. Follow instructions outlined (see
Charging
Procedures
).
1.
Read the Safety Instruction section of this manual.
2. Wear eye and ear protection.
3. Ensure magazine is empty of all fasteners.
4. Check for smooth and proper operation of contact
trip and pusher assemblies. Do not use tool if either
assembly is not functioning properly.
NEVER
use
a tool that has the contact trip restrained in the
actuated position.
5. Keep tool pointed away from yourself and others.
6. Insert fully charged battery pack.
Using the Trigger Lock-off (Fig. G)
WARNING:
To reduce the risk of serious personal
injury, do not keep trigger depressed when tool is not
in use. Keep the trigger lock-off switch LOCKED (Fig. H)
when the tool is not in use.
WARNING:
To reduce the risk of serious personal
injury, lock off trigger, disconnect battery pack
from tool and remove nails from magazine before
making adjustments.
Fig. G
2
Each BOSTITCH nailer is equipped with a trigger lock-off
2
which when pushed to the right as shown in Figure H,
prevents the tool from firing a nail by locking the trigger and
bypassing power to the motor.
When the trigger lock-off is pressed to the left, the tool will
be fully operational. The trigger lock-off should always be
locked off whenever any adjustments are made or when
tool is not in immediate use.
NOTICE:
Do not store tool with battery pack installed.
To prevent damage to the pack and to ensure best
battery life, store battery packs out of the tool or
charger in a cool, dry location.
Loading the Tool (Fig. H)
WARNING:
Keep the tool pointed away from yourself
and others. Serious personal injury may result.
WARNING:
Always remove battery pack before
loading or unloading nails. Serious personal injury
may result.
WARNING:
Never load nails with the contact trip or
trigger activated. Personal injury may result.
Fig. H
8
1. Pull the pusher
8
back until it locks at the rear of the
magazine.
2. Insert fasteners into the rear of the magazine.
3. Release the pusher.
CAUTION:
Keep fingers clear of pusher to
prevent injury.
Unloading The Tool (Fig. H)
WARNING:
The trigger lock-off should always be
locked off whenever any adjustments are made or
when tool is not in use.
1. Pull the pusher back until it locks at the rear of
the magazine.
2. Tip the tool up until the nails slide freely out the back of
the magazine. Release the pusher.
3. Open the jam clear door on the nosepiece to verify
there are no nails remaining.
Mode Selection (Fig. I)
WARNING:
Always wear proper eye [ANSI Z87.1
(CAN/CSA Z94.3)] and ANSI S12.6 (S3.19) hearing
protection when operating tool.
The BOSTITCH cordless nailers are assembled in accordance
with the ANSI Standard SNT-101-2002.
The finish nailer is capable of firing nails using bump
actuation or sequential actuation. If you would like to
have the bump actuation mode disabled, have the tool
serviced by an authorized BOSTITCH service center. Before
operating this tool, look at the selector switch to determine
the actuation mode. Read all instructions before selecting
actuation mode.
