WARNING!:
Under no circumstances should a naked flame be used to check for leaks.
VERY IMPORTANT: DISCONNECT THE GAS CYLINDER WHEN THE BARBECUE IS
NOT IN USE.
DISCONNECTING THE GAS CYLINDER
1. Turn OFF all knobs
2. Completely close the gas tap of the gas cylinder (turn clock-wise until the knob stops).
3. Remove the pressure regulator from cylinder by turning clockwise.
4. Replace the protective cover on the tap of the gas cylinder.
BARBECUE LIGHTING INSTRUCTIONS
WARNING!:BEFORE IGNITING
Check the gas supply hose before turning the gas “ON”. In case of visible damage or rips, the
hose must be replaced before use. The new gas supply hose must be according AS/NZS 1869.
VERY IMPORTANT!: ALWAYS INSPECT THE HOSE BEFORE EACH USE OF THIS
BARBECUE.
IGNITING THE MAIN BURNERS OF THE BARBECUE:
1. Read all instructions before igniting the burners.
2. Turn all knobs to
OFF
and open the gas tap of the gas cylinder.
3. Remove lid before lighting.
4. Press and turn the control knob counter-clockwise to the HI position. The built-in igniter
clicks and simultaneously ignites the jet flame and burner. If the burner does not ignite within
5 seconds,
IMMEDIATELY
turn the control knob to
OFF
, wait for 5 minutes until all gas has
disappeared and repeat the ignition procedure.
5. The LO position is obtained by turning the knob fully counter-clockwise.
6. Adjusting the control knob to your heat requirements can now control the flame.
WARNING!:
CHECK ALL GAS CONNECTIONS BEFORE EACH USE. DO NOT IGNITE THE
BARBECUE WHEN SMELLING ANY GAS.
!
7