10
System Settings
MIDI
Parameter
Value
Explanation
SYN
Synchronizing the Tempo (MIDI Sync)
You can synchronize the tempo to MIDI clock data received via the MIDI IN connector or the USB port.
You can also use a MIDI cable to synchronize two RC-202 units.
Reference
For more detailed information about MIDI and synchronization, refer to “MIDI settings” (Owner’s Manual).
AT
(default)
The RC-202 will normally operate using its internal tempo, but will synchronize the tempo to MIDI clock if MIDI
clock data is being input via the MIDI IN connector or the USB port (AUTO).
Choose the “AUTO” setting if using the RC-202 as a slave device.
INT
The RC-202 will operate using the phrase memory tempo specified within the unit (INTERNAL).
Choose the “INTERNAL” setting if you don’t want to synchronize the RC-202 to an external device.
SRC
Choosing MIDI or USB for Synchronization (MIDI Sync Source)
Specifies whether the RC-202 will synchronize to the tempo data from the USB port or the tempo data from the MIDI IN connector when MIDI Sync is
“AUTO.”
AT
(default)
When connected via USB, the RC-202 will synchronize to the tempo data from the USB port. When not connected
via USB, it will synchronize to the tempo data from the MIDI IN connector.
MID
The RC-202 will synchronize to the tempo from the MIDI IN connector.
RX
MIDI Receive Channel
1–16 (default: 1)
Sets the MIDI channel used for receiving MIDI messages.
OMn
MIDI Omni Mode
OFF
Messages will be received only on the channel specified by the MIDI Receive Channel setting.
ON
(default)
Messages are received via all MIDI channels, regardless of the MIDI Receive Channel settings.
TX
MIDI Transmit Channel
1–16
Sets the MIDI channel used for transmitting MIDI messages.
Rx
(default)
The MIDI transmit channel will be the same as the MIDI receive channel.
PC
MIDI Program Change Out
OFF
MIDI program change messages will not be transmitted.
ON
(default)
MIDI program change messages will be transmitted.
