5
Panel Descriptions
* If this indicator goes dim or no longer lights while
an effect is ON, the battery is near exhaustion and
should be replaced immediately. For instructions on
changing the battery, refer to “Changing the
Battery” (p. 12).
* The CHECK indicator shows whether the effect is
being applied or not. It does not indicate whether
the power to the device is on or not.
3. DIRECT OUT Jack,
OUTPUT (MONO) Jack
The output jacks are used to connect the unit
to an amplifier or another effects unit.
* Output may vary according to the connections.
Refer to “Outputting the Direct Sound and Octave
Sound Separately” (p. 11).
4. GUITAR IN Jack, BASS IN Jack
These jacks accept input signals (coming
from a guitar, a bass, some other musical in-
strument, or another effects unit).
* The unit’s functions differ according to how it is
connected. Refer to “Connections” (p. 8).
* When running the unit on battery power, the
GUITAR IN and BASS IN jacks double as power
switches. Power to the unit is turned on when you
plug into the GUITAR IN or BASS IN jack; the
power is turned off when the cable is unplugged. Be
sure to disconnect any cord plugged into the GUITAR
IN or BASS IN jack when not using this effects
device. When the AC adaptor is used, the power
remains on at all times, and this function is disabled.
5. Pedal Switch
Used for switching effects on/off.
6. Thumbscrew
When this screw is loosened, the pedal will
open, allowing you to change the battery.
* For instructions on changing the battery, refer to
“Changing the Battery” (p. 12).
OC-3_e1.book 5 ページ ２００３年７月１１日 金曜日 午後６時４７分
