Boss Snowplow TGS 1100, Руководство пользователя

Страница: 5 / 20

Setup
Note:
Either the slide-in or RT3 attachment is required to
install this machine. Contact your Authorized BOSS Dealer
for more information.
Installing the Wire Harness
DANGER
Vehicle engines contain moving parts and can
become extremely hot, capable of causing severe
burns and serious bodily harm.
Stop the engine and allow it sufficient time to cool
down before installing this kit.
DANGER
Vehicle batteries can cause dangerous electrical
shocks that could lead to severe burns or death.
Disconnect your battery before installing this kit.
1. Secure the brown and white connector on the wire
harness (
Figure 3 ) to the center of your vehicle’s rear
bumper with a cable tie.
2. Route the wire harness along the driver-side frame-rail
and into the engine compartment, and secure it with
cable ties.
Note:
Keep the wire harness away from any hot or
moving parts.
3. Insert the controller connector through the firewall and
into the vehicle cab, and secure it with cable ties.
Note:
Route the connector to the location that you
want to install your controller.
4. Connect the black ring connector to the negative (-)
battery terminal (
Figure 3 ).
5. Connect the red ring connector to the positive (+)
battery terminal (
Figure 3 ).
6. Wrap all of the excess wire and secure it in the engine
compartment with cable ties..
1
2
3
4
G031006
Figure 3
1. Red ring connector 3. Controller connector
2. Black ring connector 4. Brown and white connector
5