Boss Snowplow Snowrator SNR24001, Руководство пользователя

Страница: 29 / 48

g019728
Figure 33
1. Cover nut 4. Foam element
2. Cover 5. Paper element
3. Wing nut 6. Base
4. Remove the cover.
Note:
Be careful to prevent dirt and debris from
falling into the base.
5. Remove the foam and paper elements from the
base (
Figure 33 ).
6. Remove the foam element from the paper
element (
Figure 33 ).
7. Inspect the foam and paper elements, and
replace them if they are damaged or excessively
dirty.
8. If the paper element is excessively dirty, replace
it.
Note:
Never try to brush dirt off the paper
element; brushing forces the dirt into the fibers.
9. Clean the foam element in warm, soapy water
or in a
nonflammable solvent.
Note:
Do not use fuel to clean the foam element
because it could create a risk of fire or explosion.
10. Rinse and dry the foam element thoroughly.
11. Dip the foam element in clean engine oil, then
squeeze out the excess oil.
Note:
Excess oil in the foam element restricts
the air flow through the element and may reach
the paper filter and clog it.
12. Wipe dirt from the base and the cover with a
moist rag.
Note:
Be careful to prevent dirt and debris from
entering the air duct leading to the carburetor.
13. Install the air-cleaner elements and ensure that
they are properly positioned.
14. Securely install the cover with the nut.
Servicing the Engine Oil
Engine-Oil Specifications
Oil Type: Use 4-cycle motor oil that meets or exceeds
the requirements for API service category SJ or
higher.
Engine Oil Capacity: 1.1 L (1.2 US qt)
Viscosity: Use SAE 10W-30 for general use.
Checking the Engine-Oil Level
Service Interval: Before each use or daily—Check
the engine-oil level.
Note:
Check the oil when the engine is cold.
WARNING
Contact with hot surfaces may cause personal
injury.
Keep your hands, feet, face, clothing and
other body parts away the muffler and other
hot surfaces.
Important:
Do not overfill the crankcase with
oil or damage to the engine may result. Do not
run the engine with oil below the low mark or the
engine may be damaged.
1. Clean around the oil dipstick.
2. Remove the oil-fill cap/dipstick and wipe the end
clean (
Figure 34 ).
29