Boss Snowplow RT3 HTX, Руководство по установке

Страница: 17 / 28

g032936
Figure 30
1. Vertical left headlight
centerline 5. Brightest points
2. Vehicle centerline 6. Distance between
headlight centers
3. Vertical right headlight
centerline 7. Distance from ground to
headlight centers
4. Horizontal headlight
centerline
5. Mark the vertical headlight centerline on the
screen (
Figure 30 ).
6. Mark the horizontal headlight centerline on the
screen (
Figure 30 ).
Note:
The horizontal headlight centerline
should be the distance from the ground to the
center of the headlight.
7. Adjust the plow headlights until the brightest
part of the plow low-beam lights are aligned as
shown in
Figure 30 .
8. Tighten the 4 bolts (1/4 x 3/4 inch) securing each
headlight to the headlight brackets and torque
them to 8 N∙m (6 ft-lb).
Important:
Do not use thread-locking
compound on these bolts.
9. Tighten the bolt (3/8 x 1 inch) securing each
headlight-bracket to the light bar and torque
them to 31 N∙m (23 ft-lb).
Important:
Do not use thread-locking
compound on these bolts.
Product Overview
g212252
Figure 31
1. Hydraulic reservoir fill
elbow 4. Coupler
2. SmartHitch2 switch 5. Kickstand
3. D-Force accumulator
(optional)
Controls
Kickstand
Pull the kickstand spring pin to raise and lower the
kickstand.
g033059
Figure 32
1. Kickstand spring pin 2. Kickstand
17