Boss Snowplow RT3 HTX, Руководство по установке

Страница: 7 / 28

g032918
Figure 7
1. Clevis pin 4. Lift cylinder
2. Push-frame assembly 5. Coupler tower
3. Hairpin cotter
9. Secure the free end of the lift cylinder to the
coupler tower using a clevis pin and hairpin
cotter (
Figure 7 ).
Installing the Hydraulic
Hoses
1. Install the 1/4 inch end of the 45 cm (18 inch)
hose to the middle fitting on the hydraulic
manifold (
Figure 8 ). Turn the fitting until it is
finger tight, then turn it 2 to 3 more times.
Important:
Do not overtighten.
g032919
Figure 8
1. 90° fitting 4. Middle fitting
2. 86 cm (34 inch) hose 5. Right fitting
3. Left fitting 6. 45 cm (18 inch) hose
2. Install the 3/8 inch O-ring end of the 45 cm (18
inch) hose to the lower fitting on the lift cylinder
(
Figure 8 ). Turn the fitting until it is finger tight,
then turn it 2 to 3 more times.
Important:
Do not overtighten.
3. Using thread compound, install a 90° fitting
to the right angle cylinder located on the
push-frame assembly (
Figure 8 ).
Note:
The fitting should be installed at a 45°
angle pointing forward.
4. Install the 1/4 inch end of the 86 cm (34 inch)
hose to the right fitting on the hydraulic manifold
(
Figure 8 ). Turn the fitting until it is finger tight,
then turn it 2 to 3 more times.
Important:
Do not overtighten.
5. Install the 3/8 inch end of the 86 cm (34 inch)
hose to the previously installed 90° fitting (
Figure
8 ). Turn the fitting until it is finger tight, then turn
it 2 to 3 more times.
Important:
Do not overtighten.
6. Repeat steps 3 through 5 on the left side.
7. Remove the plug on the upper fitting on the lift
cylinder (
Figure 9 ).
7