4.
Secure the left headlight to the headlight bracket
using 4 bolts (1/4 inch), split lock washers, and
flat washers (
).
Important:
Do not use thread locking
compound on these bolts.
Note:
Do not tighten the fasteners at this time.
5.
Repeat steps
and
for the right headlight
bracket and headlight.
6.
Insert the headlight connectors on the wire
harness to the back of the headlight housing
(
). The short length connects to the
left headlight and the long length connects to
the right headlight.
g036655
Figure 14
1.
Cable ties
2.
Short wire harness
7.
Secure the wire harness to the light bar using 3
cable ties as shown in
.
Installing the Blade Guides
and Filling the Hydraulic
Reservoir
1.
Attach the blade guides to the plow blade using
4 bolts (5/16 x 1 inch) and 4 self-locking nuts
(
).
g036656
Figure 15
1.
Self-locking nut (5/16 inch)
3.
Bolt (5/16 x 1 inch)
2.
Blade guide
2.
Ensure that the lift cylinder is completely
collapsed.
Note:
The lights should tilt forward.
3.
Remove the fill cap from the hydraulic reservoir
(
).
g036657
Figure 16
1.
Fill cap
2.
Hydraulic reservoir
4.
Slowly fill the reservoir with BOSS
high-performance hydraulic fluid until it
accepts no more.
12
Содержание RT3 EXT
