www.bia.lighting | [email protected]
page 2 / 2
PRODUCT MANUAL
COPYRIGHT BIA
©
2020
V
11.20
DIMENSION DIAGRAM
5
4
4
3
2
24V single
conduit
+
-
canister
42mm
1100mm
Ø31mm
Ø50mm
Ø35mm
150mm
Ø50mm
INSTALLATION INSTRUCTIONS
A
DIRECT INSTALLATION INTO
DECKING
1.
Before commencing installation, ensure the main power is
switched off.
2.
Measure and cut hole to 33mm.
3.
Lay conduit and prepare wiring.
4.
Connect and waterproof cables accordingly.
5.
Hold the clips and gently push luminaire into place. The face
of the luminaire must be flushed against the installed surface.
B INSTALLING INTO A CANISTER
1.
Before commencing installation, ensure the main power is
switched off.
2.
Canisters are to be installed prior to concrete work. Please
plan accordingly and allow for adequate drainage.
3.
Secure canisters into intended position. Lay conduit and
prepare wiring.
4.
Connect and waterproof cables accordingly.
5.
After the concrete has cured, install luminaire by holding the
clips and gently push luminaire into canister. The face of the
luminaire must be flushed against the installed surface.
33mm
IMPORTANT NOTE:
All connections made must be
waterproofed to the appropriate
IP rating for the application.
Warranty is void if connection
IP ratings are not met.
Basic wiring chart
Control gear and wiring requirements may differ
depending on quantity and application. Please
verify before installation.