Bose SOUNDTOUCH 300, Руководство пользователя

Страница: 25 / 990

E N G L I S H - 2 5
S E T T I N G U P T H E U N I V E R S A L R E M O T E C O N T R O L
Programming the universal remote control
The universal remote control has four programmable source buttons ( , ,
and ). You can program these buttons to control your TV, cable/satellite box, DVD or
Blu-ray Disc™ player, game system, DVR or other auxiliary source by entering the code
for your source’s brand. There may be several codes for your source. You may need to
perform this procedure multiple times to locate the correct code.
Locate the code
1. Power on your source.
2. Locate the code for your source’s brand in the Universal Remote Control Setup
Guide (provided).
Enter the code
1. On the remote control, press and hold the appropriate source button ( , ,
or ) until all six source buttons glow, then release. For example, to program
your TV, press and hold until all six source buttons glow, then release.
The appropriate source button continues to glow.
2. On the number keypad, enter the code for your source’s brand and press .
Test the code
1. Test the source for basic functions by following the instructions for your source:
• TV : press the channel buttons. Press . The settings menu appears.
Press and to navigate.
• Cable/satellite box : press . The programming guide appears.
Press and to navigate.
• DVD or Blu-ray Disc™ player : press . The settings menu appears.
Press and to navigate.
• Game system : press and to navigate through your menu.
2. Based on your source’s response to basic functions:
• Remote responds accurately : press to exit programming and save
your settings.
• Remote does not respond or does not respond accurately :
– If your source button glows : press to move to the next code. Repeat steps
1 - 2 in “Test the code.” You may need to repeat this procedure 30 or more times.
If all six buttons blink three times, you have cycled through all codes
for your source.
– If your source button is off : your remote exited programming mode. Repeat
steps 1 - 2 in “Enter the code” and steps 1 - 2 in “Test the code.”
Note:
Your source may not be compatible with universal remote controls or may
not accept IR (infrared) signals. Refer to your source owner’s guide for more
information.